View Full Version : Raiders pockets
Kaplan
03-02-2011, 02:21 AM
I sent a diagram to Magnoli to make me another jacket, and I used the measurements of my USW SL size XL as a guide because it fits me well. I made a diagram to demonstrate the pocket placement that I wanted but ended up putting the USW pocket measurements on it that are too big because I don't have anything better to work from.
Where can I figure out what size my pockets and flaps should be? If Todd's jacket is more accurate in the pockets does anyone have a size 46 (or equal to the Legend XL) that they could measure for me? I really want to get this jacket right.
:help:
RCSignals
03-02-2011, 04:29 AM
The TN Raider pocket size is listed here.
Have you asked Magnoli what he recommends?
Kaplan
03-02-2011, 12:44 PM
The TN Raider pocket size is listed here.
Have you asked Magnoli what he recommends?
Thanks for your reply RC. I just dumped a bunch of specs in his lap and he said he could get it done. I should have waited until all of my homework was done. :doh:
Kaplan
03-02-2011, 07:29 PM
The TN Raider pocket size is listed here.
I'm trying to find it. Would you mind pointing me in the right direction? thanks.
RCSignals
03-02-2011, 07:50 PM
You can find much of it in this thread
http://www.fortuneandglory.org/index.php?topic=1190.0
Pocket is 7-3/4" high including flap, 6-3/8" to 6-1/2" wide. Pocket flap is wider than the pocket about 63/4" wide
a 'tolerance' of about 1/8" would not be unreasonable
Kaplan
03-02-2011, 09:09 PM
Thanks again! That's for Ford's size 40 jacket right? How would I convert those numbers to look to scale on a size 44-46 jacket?
Gunslinger
03-02-2011, 11:35 PM
My jacket is pretty close to a 44 and it is unaffected with the same specs.
RCSignals
03-03-2011, 12:11 AM
Thanks again! That's for Ford's size 40 jacket right? How would I convert those numbers to look to scale on a size 44-46 jacket?
I wouldn't add anything
Powered by vBulletin® Version 4.2.0 Copyright © 2022 vBulletin Solutions, Inc. All rights reserved.